Summers Superchisel - 5-Section Bedienungsanleitung PDF herunterladen (Seite 24)

2-12

SECTION 2 – SET-UP OF PART 2 WING

NOTE: It is recommended to set up both sides of the machine at the same time. The left hand side

will be the only one shown.

1. Insert eyebolts (8K1683) into part 2 wing lift cylinder bases.

– Leave eyebolts loose, they will need to be adjusted after charging hydraulic system.

2. Install four 4-1/2”x16” (8D9466) cylinders onto part 1 wings with pins provided.

3. Attach part 2 wing to part 1 wing with 8T3606 pins, 7/16” x 3-1/2” retaining bolts and locknuts.

– Grease zerks should point towards the front of the machine.

4. Fasten cylinder attach brackets (8T4224) with 3/4” u-bolts.

– Locate bracket 277” on 50’-54’, 301” on 56’-60’ from center of machine.

5. Insert eyebolts (8K1683) into cylinder attach brackets.

– Tighten 1-1/2” nuts so the same amount of threads are above top nut on all eyebolts.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 97 98

Keine Kommentare

Summers Superchisel - 5-Section Bedienungsanleitung Seite 24