Summers Superchisel - 5-Section Bedienungsanleitung PDF herunterladen (Seite 40)

2-28

SECTION 2 – CONNECTING AND SEQUENCING WING LIFT

1. Charge wing lift cylinder system.

– Block rod end of cylinders up so that cylinder shafts can be extended without hitting any-

thing.

– Fully cycle cylinders several times to make sure that all air has been removed from the sys-

tem.

– Leave cylinders in fully extended position.

2. Connect rod end of 5 x 36” cylinders to part 1 wing.

– Install wing lift pin, rollers and washers onto the wing and cylinder rod tube. Secure pin with

8T3810 washer and roll pin.

– The 8L0250 1/4” thick washers must slide freely inside wing amecuts.

– The drawing below shows an end view of this connection.

– Grease rod end tube on 5 x 36” cylinders before lifting wings. Also grease part 2 wing pivot

pins.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 97 98

Keine Kommentare

Summers Superchisel - 5-Section Bedienungsanleitung Seite 40